CompuLab SBC-FITPC2 Manuel d'utilisateur télécharger pdf (Page 20)

5 RESERVED 25 GPIO0

6 GND 26 RESERVED

7 RESERVED 27 GPIO9

8 RESERVED 28 GPIO9

9 GND 29 GND

10 RESET_IN 30 RESERVED

11 RESERVED 31 RESERVED

12 GND 32 RESERVED

13 SMB_CLK 33 GND

14 SMB_DAT 34 LPC_AD0

15 GND 35 LPC_AD1

16 RESERVED 36 LPC_AD2

17 RESERVED 37 LPC_AD3

18 RESERVED 38 LPC_FRAME

19 +3.3V_STBY 39 GND

20 +3.3V_STBY 40 LPC_CLK

Note: reserved pins must be left unconnected. Connecting them to anything may lead to

system malfunction.

Total allowed consumption from 5V should be less than 500mA,

from 3.3V less than 300 mA

5. Mechanical Considerations and Connectors’ Location

The 3D solidworks model and “dxf” assembly files of the SBC-FitPC2 board may be

downloaded from [Developer] >> [fit-PC2] section of CompuLab’s web-site.

6. Operating Temperature Ranges

The information in this section refers to the SBC-FitPC2 board only. For temperature

ranges of off-board components such as the hard disk or WLAN module, please refer to the

component’s datasheet.

The SBC-FitPC2 is available with three options of operating temperature range:

Range Temp. Description

Commercial 0

to 70

C Sample cards from each batch are tested for the lower

and upper temperature limits. Individual cards are not

tested.

Extended -20

to 70

C Every card undergoes a short test for the lower limit

1 2 ... 15 16 17 18 19 20 21

Pas de commentaire

CompuLab SBC-FITPC2 Manuel d'utilisateur Page 20